Changing the club loft
Place the shaft under your left arm, with the club head face
down in your right hand, use your left hand to turn the locking
lever 2 to 2 1/2 turns. Rock the club head back and forth until
the desired club number is between the i on the shank
and the black line on the back of the head. (Choose i for
iron, W for wedge or the P for the putters).
Click here for YouTube video: http://www.youtube.com/watch?v=hFSwb4IjuJ4
#8 iron setting
#2 putter setting
coupler in the socket
Changing the locking lever position
Turn the locking lever 6 turns. Set the shank socket in a different
position on the hex coupling nut. (Align the i line and
a lower hour number on the coupling nut). Turn the lever
back to lock. The lever should be vertical with the shaft, if
not, move the shank socket to another position on the coupling
nut. (Lower your number if lever tightens past shaft.) Once
you understand this, it only takes a few seconds to change the
locking lever position. After breaking in, the only time you
will need to adjust the lever is after disassembly for cleaning.
To extend and lock shaft, hold the grip end in your right hand
and the head in your left hand and snap open firmly. To shorten
for travel, hold shaft near the head and tap firmly on a hard
surface (concrete). Place shaft on shank taper to lock. To lock
the shaft open it must be clean. Just a little water and twisting
action against each step is all that's needed to maintain a
solid lock on the shaft. No oil, Rinse well.
Just use water. No oil or lubricant is needed. All head parts
are Stainless Steel. Do not use oil or wax on the shaft, just
soap and water and rinse well, then dry.
To reposition the lever so that it is parallel with the shaft